The boat featured is not currently for sale by Boatshed. The boat information and images presented are part of Boatshed’s back catalogue of the 20,000+ boats we have listed in the last 15 years and appear here for general information and guidance purposes about Boatshed and our boat selling systems and services
Center Console Port Townsend Bay 19 Launch

I want to see full spec & all the high res photos of this boat ,

Login or Register

Boat REF#

Sold / Unavailable


unknown year


Underwater profile

Port Townsend, WA USA - Shown by Appointment


I want to see full spec & all the high res photos of this boat , register me now or login

Extra Details

Designer Bob Cunningham
Builder Bob Cunningham
Lying Port Townsend, WA USA - Shown by Appointment
Fuel capacity 25.0 USG Total - 1 Tanks


Full engine controls and instrumentation are installed for a Yamaha 70 outboard motor (not included). This model typically retails for less than $9,000. The Yamaha 70 HP outboard provides for economical fuel consumption while allowing the boat to achieve planing speeds.

A 25 gallon fuel tank is installed at the center console.

Wired for a single 12 volt battery (not included);
Electrical switch panel installed


Length 19'0"
LWL 16'4"
Beam 7'1"
Draft Max 0'10"
Airdraft 3'1"
Displacement 1,500.3lbs
Storage Dry storage


Construction Wood
Underwater profile Planing
Finish Paint finish

This is a new, custom built wooden center console launch designed for Northwest waters.

The design features a high freeboard for a dry ride, a wide transom for stability, a v-shaped entry to cut through chop, and a balance of moderate deadrise and beam for a soft ride at planing speeds.

Only the best materials were used in construction. The keel is of White Oak. The framing, planking, and decking is Sapele, a type of African Mahogany that is known for its hardness, beautiful grain structure, and ability to take a finish in a dark red-brown tone. This finish is seen on the coaming and trim and contrasts beautifully with the smooth white Z-Spar High Gloss paint finish and ivory Interlux Interdeck deck coating.

Fasteners are silicon bronze screws. The boat is constructed traditionally in carvel planking with cotton in the seams and seam compound. Bedding compound is also used at joints in the framing and structure as needed. Floors are Sapele with marine plywood lamination for stiffness with reduced weight. The boat features a Brazilian teak cockpit sole with removable hatch panels and a teak grate at the helm.

Length overall: 19 feet.

Nav Equipment

Navigation lights tick

Deck Gear

Trailer tick

The boat features a ventilated anchor locker in the bow with ample space for ground tackle and spare items.

The helm position includes a stainless steel back rest with a padded cushion, a sliding helm seat, and cushions for the bench seats.

There are storage lockers in the seats and transom. The interior hull planking features stainless steel hold down hardware for securing deck gear underway.

Galvanized trailer included.

Safety Equipment

Horn tick

The boat is wired for an electric bilge pump (not included);

Broker's Comments

This Port Townsend Bay 19 Launch is a center console utility boat traditionally built with high quality hardwoods by shipwright Bob Cunningham in Port Townsend, Washington State USA.

The launch is designed for the rigors of the inshore coastal waters of the Pacific Northwest. The boat is a gem and showcases the beauty of rich African Sapele hardwood in contrast to gleaming white painted surfaces and an ivory deck coating. The boat is built primarily from this tropical hardwood to the highest standards of wooden boat craftsmanship.

The boat is configured with controls and instrumentation to run a Yamaha 70 HP outboard (not included) which can be purchased for under $9,000 at major retailers. This engine will enable the boat to reach planing speed with efficiency and fuel economy. Navigation lights, an electric horn, and electrical switch controls for a single battery are installed (battery not included). The boat is wired for a single bilge pump (not included). A galvanized steel trailer is included.

If you're considering a mass-produced center console such as Everglades, Scout, or Eastern Boats then you might want to consider something truly unique in our classic wooden center console launch.

These boat details are subject to contract.
Note: Offers on the asking price may be considered.

This Center Console Port Townsend Bay 19 Launch has been personally photographed and viewed by Brian Moratti of Boatshed Port Townsend. Click here for contact details.
The particulars herein are intended to give a fair description of the vessel but are not guaranteed as accurate. They shall not form part of any offer or contract for the sale of the vessel. The prospective purchaser is recommended to independently check the particulars. The vendor is not selling in the course of a business unless otherwise stated. Personal property is excluded from the sale of the vessel unless specifically included in the listing specifications above or in a Purchase Contract. Personal property may be equipment or gear not permanently attached to the vessel including but not limited to: artwork, entertainment equipment, fishing equipment, TV receivers, recreational equipment, kayaks, tools, and personal appliances. Photos that may incidentally depict owners' personal property do not convey that such items are included in the sale of the vessel unless specifically listed herein.

Comments (0)

Please note this comments section is public. Please do not post your personal details here. To enquire about purchasing this boat, please contact the broker directly at Please read our commenting guidelines before posting.

Be the first to leave a comment or ask a question...
You must be logged in to leave a comment. Login Here