The boat featured is not currently for sale by Boatshed. The boat information and images presented are part of Boatshed’s back catalogue of the 25,000+ boats we have listed in the last 20 years and appear here for general information and guidance purposes about Boatshed and our boat selling systems and services

Camano 31 Trawler

£0 Sold / Unavailable
  • Boat REF#  ·  143407
  • LOA  ·  9.45m
  • Year  ·  1993
  • Construction  ·  GRP
  • Underwater profile  ·  semi-displacement
  • Berths  ·  2
  • Engine  ·  1 x Diesel 180hp, MerCruiser-Turbo (1993)
  • Lying  ·  Puget Sound
Boatshed Seattle
Boatshed Seattle

The boat featured is not currently for sale by Boatshed. The boat information and images presented are part of Boatshed’s back catalogue of the 25,000+ boats we have listed in the last 20 years and appear here for general information and guidance purposes about Boatshed and our boat selling systems and services

Extra Details

Designer Bob Warman
Builder Camano Yachts
Lying Puget Sound
Fuel capacity 100.0 G Total - 2 Tanks
Water capacity 78.0 G Total - 2 Tanks
Holding tank capacity 20.0 G Total - 1 Tanks

Mechanical

Engine 1 x Diesel 180hp
Engine make and model MerCruiser-Turbo (1993)
Engine Hours engine1= 1906
Engine Cooled Indirect
Steering Wheel
Drive Shaft
Prop(s) 4 blade
Fuel consumption (approx) 1.5 G /hour At Cruising Speed
Cruising speed (approx) 8 knots
Max speed (approx) 13.5 knots

A defined "cruising speed" as stated above is a bit of a misnomer. Thanks to the unique hull design and powerful propulsion the boat cruises very well at any speed up to its max speed. Unlike conventional semi-displacement hulls or planing hulls there is no awkward speed to avoid. So pick your favorite speed and set your throttle!

This boat has one of the few BMW / Mercruiser Diesel engines installed in the Camanos. The BMW engine is internationally known as one of the best and widely used in Europe. With only 1,906 hours on it there is certainly a lot of life remaining. The owner has maintained all the mechanical parts and recently replaced the engine heat exchangers and replaced the transmission with a new ZF transmission with a 5 year warranty.
The Webasto Diesel hydronic heat system has also just serviced and the main heating unit was replaced.
New bottom paint in August 2015.

All three batteries (two 6 volt and one 12 volt) have been replaced this year. The Newmar battery charger was also added.

Dimensions

LOA 9.45m
Beam 3.20m
Draft Min 0.99m
Displacement 8,000.0lbs
Headroom 1.91m
Storage On marina

Electrical Systems

12 volt battery, 3 batteries charged by: engine, shore power

Construction

Construction GRP
Underwater profile semi-displacement
Finish Gelcoat finish

The Camano 31 was built in Canada and is all hand-laid fiberglass. The Keelform Hull design provides excellent rough water capability. The hollow v-shaped keel lowers the center of gravity giving the boat a very stable ride.
Fuel efficient at 8 knots she burns about a gallon and a half per hour. The semi-displacement hull also allows a top speed of 15 knots.

Accommodation

Total # of berths 2
No. of double berths 2
Cabin(s) 2
Handbasin 1
Shower 1
Heads 1 heads (Electric)

The interior of this Camano 31 provides a roomy, comfortable forward berth. It includes a custom-made mattress with a V-berth cut out. The owner has provided special steps to make it easy to climb in and out. With the standard twin reading lights, opening ports and night stands, this large forward berth makes for great sleeping.
The large convertible dinette provides addition sleeping for two more.
The standard interior carpeting has been replaced with a custom wood-grained floor that looks like real wood but wears much better. It really dresses up the interior.

3 burner gas cooker/stove

Accommodation

Cooker/stove
Grill
Oven
Sink
Refrigerator
Freezer
Curtains
Cabin heating
Pressurised water system
Hot water system
Raw water wash
Non-Smokers

The interior of this Camano 31 provides a roomy, comfortable forward berth. It includes a custom-made mattress with a V-berth cut out. The owner has provided special steps to make it easy to climb in and out. With the standard twin reading lights, opening ports and night stands, this large forward berth makes for great sleeping.
The large convertible dinette provides addition sleeping for two more.
The standard interior carpeting has been replaced with a custom wood-grained floor that looks like real wood but wears much better. It really dresses up the interior.

3 burner gas cooker/stove

Deck Gear

Warps
Fenders
Davits
Bimini
Bow Thruster

Electric Simpson/Lawrence windlass (with remote control)
2 anchors
(22 lb Bruce-SS & 18 lb Danforth)
36.58m of chain
91.44m of warp
A B Inflatables dinghy (2006)
(RIB)
9.8hp outboard, Nisson, Short Shaft (2006)
The fore-deck on this boat not only provides a good sized area for just sitting around, it includes a custom storage box for deck gear and plenty of room for setting and pulling the anchor.
The Nova lift can be used setting the 9.8 HP Nissan outboard on the 10' RIB or helping out when pulling a crab or shrimp pot. (A crab pot is included with the boat). The #10 self tailing transom mounted winch also makes both of these chores easier.
Twin grab rails P&S on the cabin side provide safe access to the fore deck.
The 10' RIB is mounted on the swim step with Weaver Snap Davits.
New Bimini August 2015.

Nav Equipment

Compass
Speed
Log
Radar
VHF
GPS
Chart plotter
Autopilot
Navtex
Stereo
Clock
Barometer
Navigation lights
Fish Finder

The FURUNO radar / chart-plotter was added in 2009, as well as a new double radar arch. This puts the radar antenna up where it belongs as well as providing a place for Kayak storage racks P&S.
The FURUNO autopilot (NavPilot) was also added three years ago.
The old location for the radar antenna was utilized with the mounting of a remotely-controlled search light.
An Autohelm tri-data display provides boat speed-depth and log. The Si-Tex color fish finder, ICOM M602 VHF, and the Radio Shack CB Radio are older but in good operating condition.
A Garmin GPS is located on the Fly Bridge for back up.

Safety Equipment

Life jackets
Life buoys
Searchlight
Horn
Boarding ladder

2 bilge pumps (0 manual / 2 Electric)

Broker's Comments

The Camano 31 Trawler is well known in the Pacific Northwest, and with her Keelform hull, sturdy construction, huge fly-bridge they have earned a reputation as a very capable small cruising trawler.

This boat includes several customization's: custom wine storage cabinet in the salon, overhead storage cabinet for charts and chart books. Additionally, this vessel is registered as a LLC and participates in the WindWorks charter program in Seattle.
Built with the BMW engine these engines have proven to be exceedingly reliable and parts are readily available. ( Interestingly in 1992 - 1993 US buyers were turned off with the Volvo engines due to higher costs for parts, as such Bob Warman (the designer and builder) chose to use the BMW engine for the US market as BMW / Mercruiser was and is well known. As best as we can determine, three were built using the BMW / Mercruiser engine and there have been no complaints about this engine by any of the owners"
The owner of this boat has provided information for your reference:
______________________________________________________________________________________________
"The BMW engine website is : http://www.bmwmarine.com
Richard Langty is who I have spoken with at BMW Marine. They have complete rebuild kits for this motor for around $1600 US. The rebuild in done in the boat and the motor does not need to be removed. That's a Huge advantage over the Volvo motor! Other Camano owners are jealous of this fact.
The motor has both the Mercruiser and BMW part numbers. Richard can tell you how to read the numbers. Simply Mercruiser placed a 4 or 5 digit number in front of the original BMW number. So it is very easy to cross reference these numbers and find parts. BMW Marine’s network extends all the way back to the original factory in Belgium when the BMW Sliver paint was changed to Mercruiser Black. On my motor your can see where the original BMW casting was and it was milled off by Mercruiser. Richard Langty’s number in Ontario is 807-543-3003. "Parts can be shipped over night. That engine is one tough beast and still has another 3000 or more hours in her."

This Camano represents a outstanding deal for a savvy buyer so do call today to arrange a time to inspect.

These boat details are subject to contract.
Note: Offers on the asking price may be considered.

Tankage and dimensional information has not been verified by Waterline Boats / Boatshed Seattle and is reported based upon information obtained from the seller and from literature.

Where the particulars herein give details of a boat, whether new or used, they are intended to give a fair description of the vessel but are not guaranteed as accurate or complete. They shall not form part of any offer or contract for the sale of the vessel. The prospective purchaser is recommended to independently check the particulars and the vessel. The vendor is not selling in the course of a business unless otherwise stated. Personal property is excluded from the sale of the vessel unless specifically included in the listing specification above or in a purchase contract. Personal property may be equipment or gear not permanently attached to the vessel including but not limited to: artwork, entertainment equipment, fishing equipment, TV receivers, recreational equipment, kayaks, tools, and personal appliances. Photos that may incidentally depict owners' personal property do not convey that such items are included in the sale of the vessel unless such items are specifically listed herein. At all times, where the particulars herein give details of a new boat and/or a new boat to be supplied/built by a builder/manufacturer, or a boat to be chartered, via our introduction, we do not guarantee or assume responsibility for the accuracy or reliability of any information offered by third-party companies in respect thereof including without limitation new boat builders/manufacturers, charter companies and/or companies/businesses which are ‘Friends of Boatshed’. We shall not be responsible for, or party to, any transactions, contracts or agreements between you and such third-party providers of products or services and it is incumbent upon you to verify such details direct with such entities and contract with them at your sole discretion and on terms that you agree.